To sign up please call 1-888-323-6404 or email training@variancefinishes.com

Location:
    Variance^® Headquarters
    119 Industrial Ave NE
    Albuquerque, NM 87107

Prerequisite: General Application Training
Time: 8:00am to 4:00pm both days
Cost: $430 per person

Each student shall satisfactorily complete a full 4 x 8 sheet of each product. Certificates issued will be product specific, the products that the student learns and demonstrates proficiency in will be listed. Students do not have to attend both days to receive an Advanced Applicator Certificate. If a student is primarily interested in Brio™ and Claro™ they may chose only to take the first day, the certificate they receive will reflect this. If a student fails to demonstrate ability to produce a satisfactory finish they may re-do their board with the assistance of the instructor until the instructor feels they have learned the product sufficiently. Each student will have the opportunity to retest on a specific product after the class for an additional $50.00 if they unable to master the product during class. Each student shall finish a 6’ wall section with a bullnose corner in Claro™ and Alto™ if attending both days. If the initial application is not satisfactory it may be run again until it meets Variance^® standards. Students shall complete a satisfactory patch on each product. Patching ability will be required in order to receive product listing on the certificate.

Benefits:

• Only applicators that have been through AAT will be on the applicator list that is circulated to customers.*
• Applicators that have been through AAT will be listed in the Applicator section of the Variance^® website.
• AAT provides the training that is necessary to start doing projects immediately.

* Customers that have extensive on the job experience using Variance^® products may have the opportunity to receive certificates at the discretion of Variance^® Finishes without attending AAT.